EMD Sound Trouble in OR

Kazareh · Joined: 29 Aug 2010 Posts: 77

Hey guys, hate to report but there's a serious, serious issue in OR With the EMD sounds, particularly the Southern Crescent pack!

In OR, I am right now running the SOU CR, between Birmingham and Tuscaloosa. I am at 35% throttle, so the 567's I believe they are, are nice and purdy sounding. However, if my view strays too far from the E9's? LIke to the rear of the train where the dome car is? When I switch back up within 'range' of the E9's, they have switched to Idle sound and start revving up again.

Gaetan · Posted: Fri Jan 23, 2015 2:51 pm Post subject:

have you report that to OR ?

this sound is the same for all my F unit and Geep Unit and is available for free with my free L&N F9 Promo at the bottom of the sale page

Maybe Guys at OR can check this problem

Gaetan

Kazareh · Joined: 29 Aug 2010 Posts: 77

Will do, Gaetan.

kknobl · Joined: 26 Jul 2010 Posts: 36

I have a similar issue with any of the 567 locomotives, regardless of which set it is.

Haven't noticed the issue to speak of with the GP30 or Alco sounds.

Gaetan · Posted: Sat Jan 24, 2015 6:25 am Post subject:

If you take a look to the sms and the lots of wav sound for 567 you will see is very sophisticate setup with many stages , i don't know why OR can not run it with the same manner of MSTS can be

CRQ5508 · Joined: 29 Feb 2008 Posts: 89

I've noticed similar behavior in a wide spectrum of sound sets from various creators (including myself) in Open Rails. I think it's just how the simulator is coded. For instance, if a compressor is running and I switch to the rear end view and then back to the front, the sound loop begins again. Similar situation with dynamic brakes. If I switch to the rear and back, they start again like they were just being activated. OR is still very much a work-in-progress, and I hope it's a bug that's fixed.